This is a demo store. No orders will be fulfilled.

Industrial Hardware and Specialties is classified as an ESSENTIAL business and is fully operational.

Please read our COVID-19 Message To Our Customers.

M9 x 1 ISO x 18mm WireSert Threaded Insert for Metals - Free-Running - 18-8 Stainless - 100/pkg

SKU
35L7C-C84E-B90F20-34
$0.00
M9 x 1 ISO x 18mm WireSert Threaded Insert for Metals - Free-Running - 18-8 Stainless - 100/pkg is available to buy in increments of 100

The M9 x 1 ISO x 18mm WireSert Threaded Insert for Metals - Free-Running - 18-8 Stainless - 100/pkg is designed to quickly repair damaged threads in soft metals such as: aluminum, cast iron, magnesium, etc. This free-running insert has a M9 x 1 ISO Right-Hand internal thread and is 0.708 long.

Attributes

M9 x 1 ISO x 18mm WireSert Threaded Insert for Metals - Free-Running - 18-8 Stainless - 100/pkg


WireSert inserts also known as wire or helical threaded inserts quickly repair or reinforce tapped holes in soft metals. Manufactured from Stainless Steel 18-8, WireSert inserts provide strong internal threads that are corrosion resistant and withstand temperatures to 800 degrees fahrenheit. This free-running insert has a M9 x 1 ISO Right-Hand internal thread and is 0.708 long.Free-Running inserts should be larger in diameter than the tapped hole. Compression during installation provides maximum surface contact between the flanks of the wire insert and the tapped threads. The flexibility of WireCert inserts enhance the load bearing capacity by deflecting the residual forces into a helical, which is dispersed into the wall of the tapped hole. Order today from Industrial Hardware and Specialties.. Order today from Industrial Hardware and Specialties.

Features

  • Quickly repair damaged threads in soft metal
  • Protect tapped holes from stripping and wear
  • Made from corrosion resistant 18-8 stainless steel

Applications:

  • Soft metals: aluminum, cast iron, magnesium, etc.

Installation:

  • Drill out the hole with the specified drill
  • Confirm that the thread and pitch of the bolt match the tap.
  • Tap the hole with the specified tap.
  • Set the stop on the installation tool so the tang is centered in the slot.
  • Wind the insert into the hole with a slight downward pressure until 1/4 to 1/2 turn below the surface.
  • Remove the tang by placing the tang break tool (or installation tool) on top of the tang and striking firmly with a hammer.
More Information
ApplicationMetals
MaterialStainless Steel 18-8
Insert StyleFree-Running
DriveTang
ID Thread RotationRight-Hand
ID Thread StandardISO Metric
ID AcronymISO
OD Thread RotationRight-Hand
OD Thread StandardISO Metric
Flange/FlushFlush
Inside ThreadM9 x 1
Length18mm
Drill Size0.3750 (3/8)
Drill Size0.3750 (3/8)
Plug Tap SizeM9 x 1
Bottoming Tap SizeM9 x 1
Tang Break Off Tool - Solid Punch35L7H8-375
Threaded Prewinder Install Tool35L7HB-090100
Chrislynn Part Number84261