- 9/32" (7.1 mm) minimum hinge side
- Plus standard lockside clearance
Fasteners:
- #10-24 x 5/8" S/S Dril-Kwik (R) (metal frame)
- #1/4-32 x 3/4'' S/S machine screw (used with adjustment stud)
- # 7/16-20 x 1-3/8" S/S adjustment stud (metal/wood door)
Length Options:
- Standard and Custom
Door Reinforcement:
- Wood - None required
- Metal - Recommended 16-gauge channel at heavier weight
- For metal doors, a 1/8" (3 mm) thick reinforcement plate is recommended along the hinge edge for proper thread engagement of the adjustment studs
Frame Reinforcement:
- None required
Fire Rating:
- Up to 3 hr. metal and 90 min. wood composite
Special Features:
- 1/4" (6.3 mm) diameter Stainless Steel Pin
- Dual 6/6 Nylon bearings between each knuckle
- Door edge protection lip (both faces of door)
- Not recommended for doors with a beveled edge on the hinge side
- 1/16" (1.6 mm) inset
Note:
- For metal doors, a 1/8" (3.2mm) thick reinforcement plate is strongly recommended along the hinge edge for proper thread engagement of the adjustment studs.
- Any nonstandard length hinge may require a custom hole pattern based on the requested length. Consult Hager Companies to address the field prep for the doors and frames.
